Lanbowan 4.9-6.5Ghz 5GHz 19dBi Mimo Sector Antennas (ANT4960D19B-120DP) [Formerly the ANT5158D19B-120DP]

Installation Requirements

• 13mm wrench

• Shielded Category 5 (or above) cabling should be used for all wired Ethernet

connections and should be grounded through the AC ground of the PoE.

We recommend that you protect your networks from the most brutal environments and

devastating ESD attacks with industrial grade shielded Ethernet cable.

Bracket Installation

① Open the waterproof cover，attach the RF Cables to the connectors of antenna

② Press the bracket handle，align the mounting tabs on the back of the Station with

the four mounting slots on the bracket，Slide the Rocket down until it locks into place.

③ Unscrew the plastic nut on the interface of station

④ Connect the other end of the 2 RF cables to the station and close waterproof cover.

⑤ Secure the Slotted U-Bracket to the upper Mounting Lugs of the antenna using two nuts.

Secure the Slotted U-Bracket to the lower Mounting Lugs of the antenna using two nuts.

⑥ Open the antenna small fixing clip, fix the two small fixing clips to the pole

with the disc mother, and mount the antenna to the pole.

0.png Note: The mounting assembly can accommodate a Ø 30 - 70 mm pole.

⑦ Completed installation.

⑧ The antenna has an Mechanical downtilt of 4°. To further adjust the elevation angle:

a. loosen four bolts on the U bracket and two butterfly nuts on the pole clamp.

b. Slide the antenna to the desired tilt.

（The brackets may slide along the pole, depending on the angle of the elevation tilt）

c. Tighten all bolts and nuts to approximately 25 N-m.

Technical Specification